B9S aktualisieren
Für Support auf Englisch, bitte um Hilfe auf dem Nintendo Homebrew Discord.
If you appreciate this guide, we accept Donations.
Required Reading
Diese Seite ist für Nutzer, die bereits boot9strap nutzen, jedoch ihre Installation auf die aktuellste Version aktualisieren wollen.
While we believe that custom firmware is safe for online use, there have been online network bans in the past, primarily for cheating and suspicious eShop behavior.
Was du brauchst
- The latest release of SafeB9SInstaller
- The latest release of boot9strap (
boot9strap-1.3.zip
; not thedevkit
file, not thentr
file) - The latest release of Luma3DS
Anleitung
Schritt I - Vorbereitungen
Überschreibe für alle Schritte dieses Abschnitts bereits vorhandene Dateien auf der SD-Karte.
- Stecke deine SD-Karte in deinen Computer
- Erstelle einen Ordner namens
boot9strap
im Stammverzeichnis deiner SD-Karte - Kopiere
boot9strap.firm
undboot9strap.firm.sha
aus der boot9strap.zip
in den/boot9strap/
-Ordner auf deiner SD-Karte - Copy
SafeB9SInstaller.firm
from the SafeB9SInstaller.zip
to the root of your SD card and rename it toboot.firm
- If a
boot.firm
already exists, replace it
- If a
-
Stecke deine SD-Karte nun wieder in deinen 3DS
Schritt II - Installation von boot9strap
- Schalte deine Konsole an
- This should automatically launch SafeB9SInstaller
- Warte, bis alle Sicherheitsprüfungen abgeschlossen sind
- Gib die Tastenkombination zur Bestätigung ein, wenn danach verlangt wird
- Once it is completed, force your device to power off by holding down the power button
- Deine Konsole wird solange nur zum SafeB9SInstaller-Bildschirm starten bis die nächste Sektion abgeschlossen wurde
Schritt III - Luma3DS aktualisieren
- Stecke deine SD-Karte in deinen Computer
- Copy
boot.firm
andboot.3dsx
from the Luma3DS.zip
to the root of your SD card, replacing the existing file - Stecke deine SD-Karte nun wieder in deinen 3DS
- Schalte deine Konsole an
Schritt IV - Luma3DS konfigurieren
Dieser Abschnitt wird nur benötigt, wenn du nach dem Neustart im Luma3DS-Konfigurationsmenü landest.
- Verwende im Konfigurationsmenü von Luma3DS den Knopf (A) und das D-Pad, um folgendes zu aktivieren:
- “Show NAND or user string in System Settings”
- Drücke (Start) zum Speichern und neustarten